GE 197D3351P003 About crisper removal, About the automatic icemaker, Safety, Crisper Removal

About crisper removal. www.GEAppliances.com

Not all features are on all models.

Safety

Crisper

Guides

When replacing the crispers, make sure you slide them through the crisper guides.

Crisper Removal

Crispers can easily be removed by tilting up slightly and pulling past stop location.

If the door prevents you from taking out the crispers, the refrigerator will need to be rolled forward until the door opens enough to slide the crispers out. In some cases, when you roll the refrigerator out, you will need to move the refrigerator to the left as you roll it out.

Instructions Operating

About the automatic icemaker.

A newly-installed refrigerator may take 12–24 hours to begin making ice.

Instructions

Power		Automatic Icemaker (on some models)
Switch		Icemaker The icemaker will produce seven cubes
		per cycle—approximately 100–130 cubes
		in a 24-hour period, depending on freezer
		compartment temperature, room
		temperature, number of door openings
		and other use conditions.
Green		If the refrigerator is operated before the
Power Light	Feeler Arm	water connection is made to the icemaker,
		set the power switch in the O (off) position.
		When the refrigerator has been connected
		to the water supply, set the power switch to
		the l (on) position.
		The icemaker will fill with water when it
		cools to 15°F. A newly-installed refrigerator
		may take 12 to 24 hours to begin making
		ice cubes.
		Throw away the first few batches of ice to
		allow the water line to clear.
		Be sure nothing interferes with the sweep
		of the feeler arm.
		It is normal for several cubes to be joined
		together.

If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.

If ice cubes get stuck in the icemaker,the green power light will blink. To correct this, set the power switch to O (off) and remove the cubes. Set the power switch to l (on) to restart the icemaker. After the icemaker has been turned on again, there will be a delay of about 45 minutes before the icemaker resumes operation.

NOTE: In homes with lower-than-average water pressure, you may hear the icemaker cycle multiple times when making one batch of ice.

There is an upper freezer shelf above the icemaker that can be used for storage.

Installation Instructions Troubleshooting Tips

Ice Storage Drawer

To access ice, pull the drawer out.	To remove the drawer, pull it straight out
	and lift it past the stop location.

Icemaker Accessory Kit

If your refrigerator did not come already	Check the back of the refrigerator for
equipped with an automatic icemaker,	the specific icemaker kit needed for
an icemaker accessory kit is available at	your model.
extra cost.	9

Consumer Support