Operating Instructions Safety Instructions
Preparing to install the refrigerator.
Read these instructions completely and carefully.Water Supply to the Icemaker
The icemaker will have to be connected to a cold | You can order a water supply kit (containing copper |
water line. | tubing, shutoff valve, fittings and instructions) by |
| visiting our Website at www.GEAppliances.com or |
| from Parts and Accessories, |
Refrigerator Location
Do not install the refrigerator where the | Install it on a floor strong enough to support it |
temperature will go below 60°F (16°C) | fully loaded. |
because it will not run often enough to maintain |
|
proper temperatures. |
|
Clearances |
|
Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections:
| 21′ and 23′ | 25′, 27′, and 29′ |
Sides | 1/8″ (4 mm) | 1/8″ (4 mm) |
Top | 1″ (25 mm) | 1″ (25 mm) |
Back | 1/2″ (13 mm) | 1″ (25 mm) |
If the refrigerator is against a wall on either side, allow the following door clearances:
21′, 23′, 25′, and 27′ models with flat doors: 25⁄8″ (67 mm)
25′ and 27′ models with bowed doors: | 311⁄16″ (94 mm) |
29′ models with flat doors: | 45⁄16″ (110 mm) |
29′ models with bowed doors: | 53⁄8″ (70 mm) |
Consumer Support Troubleshooting Tips
Rollers
The rollers have 3 purposes:1 Rollers adjust so the door closes easily when opened about halfway. [Raise the front about 5/8″ (15 mm) from the floor.]
2 Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.
3 Rollers allow you to move the refrigerator away from the wall for cleaning.
Final leveling adjustments should be made after the refrigerator has been installed.
To adjust the rollers on 25′, 27′, and 29′models:Turn the roller adjusting screws clockwise to raise the refrigerator, counterclockwise to lower it. Use a 3/8″ hex socket or wrench, or an adjustable wrench.
Remove the base grille by opening the doors, removing the screws at each end, and pulling it straight out.
Turn the front roller adjusting screws clockwise to raise the refrigerator, counterclockwise to lower it. Use a 3/8″ hex socket or wrench, or an adjustable wrench.
Roller adjusting screws
These models also have rear adjustable rollers so you can align the refrigerator with your kitchen cabinets. Use a
16
Roller adjusting screw