SafetyInstructions
Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker (on some models)
Instructions
If the refrigerator has an icemaker, it will have to be connected to a cold water line.
Refrigerator Location
A water supply kit (containing copper tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer or from Parts and Accessories,
Operating
Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures.
Clearances
Install it on a floor strong enough to support it fully loaded.
Installation Instructions
Allow the following clearances for ease of | If a 19′, 22′ or 25′ model is to be installed next to | |
installation, proper air circulation and | a wall on the hinge side, allow 11⁄2″ (38 mm) for | |
plumbing and electrical connections: | door clearance. | |
Sides | ..............................3/4″ (19 mm) |
|
Top | 1″ (25 mm) |
|
Back | ..............................1″ (25 mm) |
|
TroubleshootingTips
CustomerService
Rollers (on some models)
The rollers have 3 purposes: | To adjust the rollers: |
1 Rollers adjust so the door closes easily when opened about halfway. [Raise the front about 3/4″ (19 mm) from the floor.]
2 Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.
3 Rollers allow you to move the refrigerator away from the wall for cleaning.
Remove the base grille by pulling out at the bottom.
Turn the two front roller adjusting screws clockwise to raise the refrigerator, counter- clockwise to lower it.
Replace the base grille by pushing forward until it snaps into place.
14
