Installation Instructions
INSTALLING THE REFRIGERATOR (CONT.)
4PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
5LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the rollers located near the bottom hinges.
Raise
Rollers
Rollers have three purposes:
•Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about 5/8″ [16 mm] from the floor.)
•Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.
•Rollers allow you to move the refrigerator away from the wall for cleaning.
To adjust the rollers on 23‘ (33” wide), 25‘ and 26‘ models:
•Turn the roller adjusting screws
clockwise to raise
the refrigerator, counterclockwise to lower it. Use a 3/8″ hex socket or wrench, or an adjustable wrench.
5LEVEL THE REFRIGERATOR (cont.)
To adjust the rollers on 23‘/25‘ CustomStyle™ models:
Turn the front roller adjusting screws clockwise to raise
the refrigerator, counterclockwise to lower it. Use a 3/8″
hex wrench with extension, or an adjustable wrench.
These models also have rear adjustable rollers so you can align the refrigerator with your kitchen cabinets. Use a 3/8″ hex wrench with extension to turn the screws for the rear rollers— clockwise to raise the refrigerator, counterclockwise to lower it.
6LEVEL THE DOORS
Adjust the refrigerator door to make the doors even at the top.
To align:
AUsing a 7/16″ wrench, turn the door adjusting screw to the right to raise the door, to the left to lower it.
NOTE:
A nylon plug, imbedded in the threads of the pin, prevents the pin from turning unless a wrench is used.
BAfter one or two turns of the wrench, open and close the refrigerator door and check the alignment at the top of the doors.
Doors should be even at top
Roller adjusting screw
Raise
7/16″ wrench
30