GE 25 About QuickFreeze.on some models, About the water filter, Instructions Operating, Safety

About QuickFreeze.™(on some models) ge.com

Safety

QuickFreeze Plate

The QuickFreeze plate is only to be used with the QuickFreeze feature. Use QuickFreeze to freeze items faster to enhance food preservation.

How to Use

Place food (wrapped in plastic wrap) on QuickFreeze plate. Turn the feature on via the LCD controls.

Some LCD Models Only:

Access By: Home > Options > Freezer Options > QuickFreeze

Activate By: Using the arrows to select the time and pressing Enter.

Deactivate By: Pressing OFF.

NOTE: While the QuickFreeze feature is enabled, the actual freezer temperature may drop as low as –3°F (–19°C). This is normal.

Instructions Operating

About the water filter.

Cartridge

Holder

Place the top of the cartridge up inside the cartridge holder and slowly turn it to the right.

Filter

Bypass

Plug

SmartWater

Water Filter Cartridge

The water filter cartridge is located in

the back upper right corner of the refrigerator compartment.

When to Replace the Filter

LCD Models:

A pop-up screen will appear on the LCD screen to remind you to replace the water filter. You can check the status of the water filter manually.

Access By: Home > Options > Dispenser Options > Reset Water Filter

Non-LCD Models:

There is a replacement indicator light for the water filter cartridge on the dispenser. This light will turn orange to tell you that you need to replace the filter soon.

The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases.

Removing the Filter Cartridge

If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down.

Installing the Filter Cartridge

There is an adapter attached to the top of the new filter cartridge.

The adapter must be removed before installing the cartridge. To remove the adapter, turn it to the left about 1/4 turn.

Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation.

Line up the arrow on the cartridge and

the cartridge holder. Place the top of the new cartridge up inside the holder. Do not push it up into the holder.

Slowly turn it to the right until the filter cartridge stops. DO NOT OVERTIGHTEN.

As you turn the cartridge, it will automatically raise itself into position. The cartridge will rotate about 1/2 turn.

Run water from the dispenser for 5 minutes to clear the system and prevent sputtering.

LCD Models:

Press FILTER REPLACED button to confirm replacement.

Non-LCD Models:

Press the SET FEATURES pad until REPLACE WATER FILTER is lit. Press and hold the ON/OFF pad for 3 seconds. WATER FILTER IS RESET will show in the window.

NOTE: A newly installed water filter cartridge may cause water to spurt from the dispenser.

Filter Bypass Plug

You must use the filter bypass plug when a replacement filter cartridge is not available. The dispenser and the icemaker will not operate without the filter or filter bypass plug.

Replacement Filters:

To order additional filter cartridges in the United States, visit our Website, ge.com, or call GE Parts and Accessories, 800.626.2002.

MSWF

Suggested Retail $36.95–$41.95 USD

Customers in Canada should consult the yellow pages for the nearest Mabe Service Center.

9

Instructions

Instructions Installation

Troubleshooting Tips Consumer Support