6.Use either Arrow key to scroll until the display reads the proper number of bytes (1, 2 or 4) as indicated in the
7.Press OK and the screen will display read CONFIG VAZL.
8.Use either Arrow key to scroll until the display reads the proper value (0 - 255) as indicated in the
9.Press OK.
10.Press the button on the device.
11.The screen will display SUCCESS.
SENDING INFORMATION TO A SECONDARY REMOTE
You can add a secondary remote to your network, and copy your primary remote’s network and device information to it.
To send information to a secondary remote:
1.Place the two remotes near each other.
2.Press and hold SETUP on the primary 45601 Advanced remote until the display reads LGHT SETUP.
3.Use either Arrow key to scroll until the display reads TRANSFER.
4.Press OK and the screen will display PRIMARY.
5.Use either arrow key to scroll until the display reads SECONDARY.
6.Press OK and the Screen will display ALL.
a.To send network and device information to the new remote, proceed to Step 7.
b.To send only network information to the new remote, use either arrow key to scroll to NTWK ONLY and proceed to Step 7.
7.Refer to the user manual for the secondary remote for programming information. Put the target (secondary) remote into programming mode so that it receives information from the primary remote. See the following section on “Copying Information to this Remote” if the target remote is a 45601 remote.
8.Press the OK key and the screen will display SENDING.
9.When screen displays SUCCESS you have successfully transferred the information.
Copying Information to this Remote
1.Place the two remotes near each other.
2.Refer to the user manual for the primary remote for programming information. Put the primary remote into programming mode so that it sends information to the secondary remote. If the primary remote is a 45601 Advanced Remote, refer to the section above on Sending Network Information.
3.On the target 45601, use either Arrow key to scroll until the display reads TRANSFER.
4.Press OK and the screen will display PRIMARY.
5.Use either arrow key to scroll until the display reads RECEIVE,
6.Press OK and the Screen will display RECEIVING.
7.When screen displays SUCCESS you have successfully transferred the information.
