GE 500A200P047 Installation Instructions, Position water line and power supply, Figure K

Models: 500A200P047

1 26
Download 26 pages 38.74 Kb
Page 19
Image 19
Step 5. Position water line and power supply

INSTALLATION INSTRUCTIONS

Step 5. Position water line and power supply

Position the water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher.

Figure K Water Power Step 8. Align water and electrical lines

Line Supply

Figure K

Step 6. Insert drain hose through cabinet

Upright dishwasher and position in front of the cabinet opening. Insert the drain hose into the hole previously drilled in the cabinet wall. If a power cord is used, guide the end through a separate hole cut for the electrical cord.

Step 8. Align water and electrical lines

Route the water line and electrical supply to their connection locations under the dishwasher. Do not connect water and electrical in this step.

Step 9. Level dishwasher

Level the dishwasher by adjusting the four leveling legs individually for correct alignment. See Figure N. Dishwasher should be level left to Step 9. Level dishwasher right and front to back for proper

dish rack operation and dishwasher performance. Dishwasher door should

be in alignment with adjacent cabinets. Figure N See Figure O.

Step 10. Position dishwasher and fasten to cabinet

Open the door and position the dishwasher tub flange 3/4Ó from the cabinet opening. Fasten the dishwasher to the underside of the countertop, using the 2 Phillips screws provided in Step 1. Be sure screws are driven straight and flush to avoid interference with door operation. See Figure O.

Installation

Figure L

Step 7. Slide dishwasher into cabinet

Slide the dishwasher into the opening a few inches at a time.

Important: Make sure that dishwasher is

centered in the opening and there is no interference with cabinets when opening

or closing the

door. Interference

may cause a

water leak when dishwasher is in operation.

Step 10. Position dishwasher and fasten to cabinet3/4"

Figure O

Instructions

As you proceed, pull the drain hose through the opening and under the sink. Make sure drain hose is not kinked under dishwasher. Check to be sure there is no interference with water line and wiring.

DO NOT PUSH AGAINST FRONT DOOR PANEL WITH YOUR KNEE. Damage to the door panel will occur.

Step 11. Connect water supply

Connect water supply line to 90¡ elbow installed in Step 4.

Figure P

Hot Water

Figure M

90° Elbow

Supply

19

Page 19
Image 19
GE 500A200P047 Installation Instructions, Position water line and power supply, Figure K, Align water and electrical lines