ge.com
When the air conditioner is turned on, it will automatically start in the default setting.
Safety Instructions
Remote Control
■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
■The remote control signal has a range of up to 21 feet.
■Make sure nothing is between the air conditioner and the remote control that could block the signal.
■Make sure batteries are fresh and installed
FAN Mode
Use the FAN at HIGH, MID or LOW to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling, a temperature setting will not be displayed.
Instructions
COOL Mode
Use the COOL mode with HIGH, MID or LOW fan
for cooling. Use the Temp INCREASE ▲ /DECREASE ▼ pads to set the desired temperature between 61°F and 86°F in 1°F increments.
A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it will take approximately 3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal
For Maximum
For Quieter & Nighttime
NOTE: If you switch from a COOL setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a COOL setting.
Care and Cleaning Troubleshooting
DRY Mode
Use the DRY mode to provide dehumidification only. The fan will run at a low fixed speed at this setting. Keep windows and doors closed for the best dehumidifying effects. When using the DRY mode, detach the exhaust hose from the unit and remove the window slider or seal the opening in the window exhaust adapter.
NOTES:
If you switch from a DRY setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a DRY setting.
The compressor runs in this mode.
Tips
AUTO Mode
Set to AUTO for the temperature and fan speed to | NOTE: DRY will also appear in the display when using |
automatically provide optimum comfort settings. | the AUTO mode. |
5
