Installation Instructions
Power cord includes a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.
1CHOOSE A LOCATION
•Place the air conditioner on a smooth, level floor strong enough to support the unit with a full bucket of water.
•Allow at least 12 inches (30 cm) of air space on all sides of the unit for good air circulation.
12″ (30 cm) | 12″ (30 cm) |
min. | min. |
•Place the unit in an area where the temperature will not fall below 65°F (18°C). The coils can become covered with frost at temperatures below 65°F, which may reduce performance.
NOTE: The portable air conditioner has rollers to aid placement, but it should only be rolled on smooth, flat surfaces. Do not attempt to roll the portable air conditioner on carpet or over objects.
2ATTACH EXHAUST ADAPTER TO WINDOW SLIDER INSIDE OPENING
•Snap the exhaust adapter into the inside opening of the window slider.
Inside
9
3ATTACH PROTECTIVE SCREEN TO OUTSIDE OF EXHAUST ADAPTER
•Use two small wood screws on each side to attach the protective screen onto the outside of the exhaust adapter.
4INSTALL RAIN DEFLECTOR TO OUTSIDE OF ADJUSTABLE WINDOW SLIDER
•Remove the appropriate plugs (save for future use) from the window slider and rain deflector to prepare for either a
Slider Window | |
Installation | Installation |
Leave these two bolts | Leave these two |
in place for | plugs in place for |
window installations | sliding window |
| installations |
Outside
Outside
5INSTALL WATER BUCKET COVER
ARemove the shipping tape from the side
of the unit and remove the water bucket.
BPull the cover
from the bucket and | Insert posts | |
into holes | ||
install it by inserting | ||
| ||
its posts into the |
| |
holes. |
|
CClose the cover and insert bucket into unit.