Spirit level

Installation Instructions

3 LEVEL THE RANGE

AInstall the oven racks in the oven and position the range where it will be installed.

BCheck for levelness by

placing a spirit level or a cup, partially filled with water, on one of the oven racks. If using a spirit level, take two readings—with the

level placed diagonally first

in one direction and then the other.

CThe rear leveling legs must be adjusted prior to moving the range into position. They can be adjusted from the bottom at the back of the range.

Adjust from

 

the bottom back

 

of range (warming

Raise

drawer models)

range

Leg leveler

Lower range

Back of range

DUse an open-end or adjustable wrench to adjust the leveling legs until the range is level.

EReplace the drawer or panel.

4FINAL INSTALLATION CHECKLIST

•Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.

•Be sure power is in service to the building.

•Note (on some models): If the clock flashes “bAd” and then “LinE” with a loud tone, the neutral connection to the range is not wired correctly. Check the terminal block connections and/or house wiring to correct.

•Check to be sure that all packing materials and tape have been removed. This will include tape on metal panel under control knobs

(if applicable), adhesive tape, wire ties, cardboard and protective plastic. Failure to remove these materials could result in damage to the appliance once the appliance has been turned on and surfaces have heated.

•Check to make sure that the rear leveling leg is fully inserted into the Anti-Tip bracket and that the bracket is securely installed.

5OPERATION CHECKLIST

•Turn on one of the surface units to observe that the element glows within 60 seconds. Turn the unit off when glow is detected. If the glow is not detected within the time limit, recheck the range wiring connections. If change is required, retest again. If no change is required, have building wiring checked for proper connections and voltage.

•Check to make sure the Clock (on models so equipped) display is energized. If a series of horizontal red lines appear in the display, disconnect power immediately. Recheck the range wiring connections. If change is made to connections, retest again. If no change is required, have building wiring checked for proper connections and voltage. It is recommended that the clock be changed if the red lines appear.

•Be sure all range controls are in the OFF position before leaving the range.

42