Installation Instructions
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and | Phillips and | Duct tape |
tape measure | Flat blade screwdrivers |
|
|
|
|
Electric drill with | ¼” pivoting hex socket |
1/8” and 3/8” bits |
|
Spirit level | Safety glasses |
|
Flashlight
cUL Listed Wire nuts
Pliers
Hammer
Metal snips
Wire Cutter/Stripper
Saber saw or Key Hole Saw
Ladder | Allen Wrench |
Additional Materials:
•120V 60Hz. 15 or 20 Amp, 2 wire with ground. Properly grounded branch circuit.
•Strain relief for junction box.
•7” round metal duct or 3¼” x 12” rectangular duct, length to suit installation.
REMOVE THE PACKAGING
•Remove parts package from the “V” shaped cardboard insert. Remove insert. Remove shipping pads.
•Lift the hood out of the box.
CAUTION:
Lift hood by grasping the outside edges of the exhaust opening on the top. Do not lift hood by the exhaust opening divider – damage will occur.
|
| Parts | |
|
| Package | |
Wood | Duct |
| |
Mounting | Hood | ||
Transition | |||
Support |
| ||
|
| ||
| Motor |
| |
| Mounted on | ||
| Skid |
|
Shipping Carton
•Remove transition duct piece from the inside of the hood. Discard screws.
•The vent hood motor is shipped secured to the skid with 4 screws. Locate and remove 2 screws on each side of the motor. Discard the shipping skid.
Hold Down Screws
Hold Down Screws
•From the inside of the hood, remove shipping screws holding the wood mounting piece to the back side of the hood. Set aside wood mounting piece and screws for later installation. Do not discard.
•Remove junction box cover and knockout.
•Install strain relief onto back or top of hood.
•Remove all tape and packing material from the hood, duct transition and motor.
1 Ft = 0.3 m 1” = 2.5 cm
11