Installation Instructions
11INSTALL FILTERS
•Remove protective film covering the filters.
•Insert the filter into the “C” clips mounted to the top of the vertical front panel.
•Tap the filter against one side to align with outside opening.
•Pull the filter down into the lower slots at the bottom of the filter support.
Junction
Box
11A INSTALL OPTIONAL COMMERCIAL FILTERS
• Remove supplied filters (if installed).
“C” Clip
Filters
Filter
Support
•Place the filter drip trays into the horizontal channel in the filter panel, located behind the filters. The grease will drain from the filters into these trays.
•Insert the filter into the “C” clips mounted to the top of the vertical front panel.
•Position the filter in the lower slots at the bottom of the filter support.
12INSTALL CONTROL KNOBS
•To remove the filters, grasp the handle, push the filter up and pull forward.
1 Ft = 0.3 m 1” = 2.5 cm
• Push control knobs onto the shafts.
13FINALIZE INSTALLATION
•Refer to the operating instructions to test all controls.
18
