Installation Instructions
7INSTALL MOTOR
•Align and engage the
slots in the blower | Motor Attachment Bracket |
assembly to the 3 hooks |
|
at the rear of the |
|
exhaust opening. |
|
• Rotate motor upwards | Motor Hooks |
until it aligns with the | |
attachment screw |
|
location. |
|
• Secure the motor to attachment bracket at the front of the opening with washer and screw provided.
• Plug the motor connector into the mating hood connector. See the illustration for the hood connector location. Touch the hood to locate and make the connection.
IMPORTANT: Hold the connector so the two square corner terminals
are at the top as you position the connector to plug it in.
8CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
If house wiring is not
A Remove | CInsert Power |
|
Junction Box | Coduit Thru |
|
Cover | Strain Relief |
|
| and Tighten |
|
| Ground | White |
| Black | |
B Check That White, Black and |
| |
Green Hood Wires Are Threaded |
| |
Thru Small Hole in Bracket |
|
DUse cUL Listed Wire Nuts
•Use wire nuts to connect incoming ground to green, white to white and black to black.
•Push wires into junction box and replace cover. Be sure wires are not pinched.
9INSTALL DUCT COVERS
To install the 12” duct cover alone:
•Place the 12” section of the decorative duct cover on top of the hood.
•Secure the cover to the top of the hood with 4 screws provided.
To install the 12” duct cover alone:
•Place the
•Secure the bottom cover to the top of the hood with 4 screws provided. See illustration, page 16.
•Extend the inside section upwards to meet the ceiling and ceiling bracket.
•Secure the duct cover to the bracket with the 2 small Phillips screws provided.
10INSTALL FILTER SUPPORT
•Tip filter support into the rear of the hood.
•Insert support tabs into the slots at the rear of the hood.
Insert Tabs into Slots
Insert 2 Screws
• Secure the support to the hood with screws as shown.
1 Ft = 0.3 m 1” = 2.5 cm
17