Installation Instructions
A | OUTSIDE TOP EXHAUST (Vertical Duct) |
INSTALLATION OVERVIEW | |
A1. | Attach Mounting Plate to Wall |
A2. | Prepare Top Cabinet |
A3. | Check Damper Operation |
A4. | Mount Microwave Oven |
A5. | Adjust Exhaust Adaptor |
A6. | Connect Ductwork |
A1. ATTACH THE MOUNTING
PLATE TO THE WALL
Remove the template from the rear wall. The mounting plate must be secured to the wall using at least 3 toggle bolts and one wood screw. The wood screw must engage a wall stud.
1Remove the toggle wings from the bolts.
2Insert the bolts into the mounting plate
through the holes designated to go into drywall and reattach the toggle wings to 3⁄4″ onto each bolt.
To use toggle bolts:
Spacing for Toggles
More Than Wall
Thickness
Mounting | Toggle Wings |
Toggle | |
Plate | Bolt |
Wall
Bolt End
3Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.
NOTE: Before tightening the toggle bolts and the wood screw(s), check again to be sure that the mounting plate is level and centered left to right.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall.
4Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. Be careful not to
12