GE 39-40425, DE68-02957A warranty Installation Instructions

Installation Instructions

B4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST (cont.)

3Carefully slide the blower motor toward the right, and lift it partially out of the opening. Note: The blower wires are long enough to allow flexible handling while performing these steps. Disconnect the wires only if it is necessary for additional flexibility.

Back of

Microwave

4Remove the two screws holding the gray-colored inlet sleeve to the blower unit. Rotate the gray sleeve as shown until the gray arrow lines up with the “B”, back exhaust. Reinstall the two screws.

Remove screws from

Gray Inlet Sleeve

Back of Microwave

5Roll the assembled blower unit so that the black-colored exhaust outlet faces the back of the microwave and the gray-colored inlet sleeve faces downward. NOTE: The gray-colored sleeve opening must ALWAYS face downward to ensure proper operation of the microwave.

	Black
	Exhaust
	Outlet
Must Face	Back of
Downward
	Microwave

6Tilt and place the blower unit back into the opening in the top of the microwave.

CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.

7Secure the blower unit to the microwave with the two screws removed in Step 2.

Retaining screw

Retaining screw

8Close the blower cover.

9Attach the exhaust adaptor to the rear of the microwave by sliding it into the guides at the top center of the back of the oven.

Adaptor

	Back of
	Microwave
	Guide
	Blower Motor Screw
Guide	Locking Tabs

Push in securely until it is in the lower locking tabs. Take care to assure that the damper hinge is installed so that it is at the top and that the damper swings freely. Reinstall the original blower motor screw through the adaptor and into the back of the microwave.

17