Installation Instructions
C | RECIRCULATING |
INSTALLATION OVERVIEW | |
C1. | Attach Mounting Plate to Wall |
C2. | Prepare Top Cabinet |
C3. | Check Microwave Assembly |
C4. | Adapt Blower for Recirculation |
C5. | Mount the Microwave Oven |
C6. | Install Charcoal Filter |
C1. ATTACH THE MOUNTING
PLATE TO THE WALL
Remove the template from the rear wall. The mounting plate must be secured to the wall using at least 3 toggle bolts and one wood screw. The wood screw must engage a wall stud.
1Remove the toggle wings from the bolts.
2Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach the toggle wings to 3⁄4″ onto each bolt.
To use toggle bolts:
Spacing for Toggles
More Than Wall
Thickness
Mounting | Toggle Wings |
Toggle | |
Plate | Bolt |
| Wall |
Bolt End
3Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.
NOTE: Before tightening the toggle bolts and the wood screw(s), check again to be sure that the mounting plate is level and centered left to right.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall.
4Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. Be careful not to
C2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
The top cabinet template will help you locate the top support screw holes and power cord cutout locations.
•Read the instructions on the TOP CABINET TEMPLATE.
•Tape it underneath the top cabinet.
•Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
19