Installation Instructions
A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
The top cabinet template will help you locate the top support screw holes, power cord and exhaust outlet locations.
•Read the instructions on the TOP CABINET TEMPLATE.
•Tape it underneath the top cabinet.
•Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
A3. INSTALL THE DAMPER
Remove rear retaining screw
A3. INSTALL THE DAMPER (cont.)
Damper
Reinstall rear retaining screw
•Close the blower cover with adaptor and reinstall rear screw.
•Remove tape holding the damper. The damper should pivot easily.
•The adaptor can be adjusted, left to right and front to back, to align with the house exhaust ductwork.
A4. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.
NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from overtightening screws.
•Place the microwave in its upright position.
•Remove the retaining screw at the rear of the motor door.
•Lift the blower motor door.
•Slide the exhaust adaptor toward the left side and into the opening.
•The adaptor should be oriented as shown.
NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps
1
Lift microwave, tilt it forward and hook slots at back bottom edge onto four lower tabs of mounting plate.
2Rotate front of oven up against cabinet bottom.
13