GE DEH-211 manual Installation for Windows NT

Installation for Windows NT 4.0

The following installation procedures assume that you are familiar with Windows NT 4.0 and your computer.

Carefully read the following notes that pertain to installing your AXS-MMS-132-095 product. Follow the steps below to install AX-S4 MMS for Windows NT on your system.

1.Insert the AXS4-MMS-132-095 CD-ROM into the CD-ROM drive.

2.If the Autorun feature is enabled on your computer, go to Step 3.

Otherwise, click on Start, select Run and enter X:\disk1\setup (where X is the appropriate CD-ROM drive designation).

3.When the AX-S4 MMS Setup initializes, you are presented with three installation choices: Typical, Minimal, and Custom. Typical (the recommended selection) will install the core AX-S4 MMS and SISCO OSI Stack components including AX-S4 MMS samples. Minimal will only install the AX-S4 MMS and SISCO OSI Stack components. Custom will allow you to select only those components that are required for your installation. When using this option, you may also choose to install the electronic copy of the AX-S4 MMS User's Guide.

4.Follow the instructions on the screen to complete the AX-S4 MMS installation.

Note: When the AX-S4 MMS Setup is complete you will be asked if you want to restart the computer. Select the option "No, I will restart my computer later." Click the Finish button.

5.Install the OSI LLC Protocol Driver for Windows NT.

Note: If you are replacing an existing version of the OSI LLC Protocol Driver, you need to remove the current version. Select the Services dialog tab, highlight the OSI LLC Protocol Driver and click the Remove button. Click on OK. Click the Close button and reboot your computer. When the system reboots, set the directory to the Windows System Drivers (System32\Drivers) and delete the file osillc.sys. The installation process will fail to load the correct OSILLC device driver if an older version of the device driver is present in the system directory.

6.Click on Start > Settings > Control Panels. From the Control Panel folder, select the Network shortcut.

7.Select the Protocols dialog tab and click the Add… button.

8.From the Select Network Protocol dialog box, click the Have Disk… button.

9.From the Insert Disk dialog box, type the path {d}:\osillc\winnt, where {d} designates the letter of your CD-ROM drive, and click on OK to accept the path.

10.From the Select OEM Option dialog box, click on OK, then click the Close button and restart your computer.

11.The following directory structure should now appear on your computer.

<Drive>:\OSILL2	All OSI Stack files
<Drive>:\AXS4MMS	All AX-S4 MMS files

Note: If you are installing for both Windows 95 and Windows NT, you should install the product into the same directory. This will allow you to share the same configuration database between both platforms.

60 • Using MMS Servers with PMCS CIMPLICITY PMCS Read-This-Book-First