D. Reverse the HANDSET HOOK by firmly sliding it out of cradle, rotating it 180°, and sliding it back into the cradle.
E. Remove the BACK COVER PLATE from the TELE- PHONE BASE UN/T by pushing in the two tabs.
F. If the wall jack is Iabelled Line
G. Thread the SHORT TELEPHONE LINE CORD through the square hole in the center of the
BACK COVER PLATE.
H. Connect a LONG TELEPHONE L/NE CORD to the jack on the telephone Iabelled DC 9V.
1.Plug the AC POWER CORD into the jack on the telephone Iabelled DC 9V.
Impotiant: Do not plug the AC PO WER CORD in- to an electrical outlet at this point.
J.Thread the long TELEPHONE L/NE CORD and the AC POWER CORD through the CHANNEL on the back of the BACK COVER PLATE so that the cords are taut at the top of the telephone. (attach the BACK COVER PLATE to the BASE so that the narrow end is at the top of the telephone).
K.Hold the phone close to the wall jack and connect the short TELEPHONE L/NE CORD to the jack.
L. Hold the telephone against the wall jack face plate so the studs on the face plate slide into the keyholes on the BACK COVER PLATE. Slide the telephone down firmly so that it is locked secure- ly in place.
M.Connect either end of the COILED CORD to the jack on the side of the TELEPHONE BASE UN/T. Connect the other end to the jack in the HAND- SET. Place the HANDSET on the HANDSET HOOK.
N. Connect the long TELEPHONE LINE CORD to the jack by the baseboard.
