GE Feb-50 E. Connect a LONG TELEPHONE L/NE CORD to the, To Disable Ringer

E. Connect a LONG TELEPHONE L/NE CORD to the

jack on the back of the telephone Iabelled L/NE 3-4.Connect the other end to wall jack(s) Iabelied 3 & 4 in the same manner described above.

F. Connect either end of the CO/LED CORD to the jack on the side of the TELEPHONE BASE UNIT. Connect the other end to the jack in the HANDSET. Place the HANDSET in the cradle.

G. Plug the AC POWER SUPPLY CORD into the jack on the telephone Iabelled DC 9V Thread the cord behind the STRAIN RELIEF. Plug the AC POWER SUPPLY into the nearest electrical outlet.

H. After you plug in the AC POWER SUPPLY you should see the /NTERCOM LED flash red and areen.

Consult the WORKSHEET above to see”which Station Number you have assigned to this telephone. Press

that same number on the MEMORY/lNTERCOM lN- DEX. The phone will beep, and the LED will start flashing red as it checks to see if this station address is already in use. If this station address is not already in use, the LED will turn off and the telephone will automatically conduct a “line check”. During the “line check” the line LED’s for each line connected will turn green. After a few seconds all LEDs will go off and you will here 3 beeps and the telephone should be fully functional.

NOTE: If you hear an error tone, the intercom number

you pressed has already been assigned to another station or the TELEPHONE L/NE CORDS are not pro- perly connected. Check the L/NE CORD connections. Check the station number assignments on your worksheet and repeat the procedure. (If you need to change the address of a station, refer to page 28 in the Use and Care Guide)

1.If you desire, you may turn off the ringer for any line or lines at any station. Press the STORE button and you should see a red LED for each L/NE button. The LED indicates the line is active and will ring. To disable a ringer press these buttons in the sequence to the right:

The LED should turn off, indicating a disabled ringer. Repeat this sequence for each ringer you wish to disable.

To turn a ringer back on: See page 23 of the accompanying USE AND CARE GUIDE.

TO DISABLE RINGER

2.	nOmRo
3.&
4.	LINE r ■
	w

Note: For complete information on the programming and use of your GE Model 2-9450 telephone, consult the accompanying USE

m AND CARE GUIDE,