O. Plug the AC POWER SUPPLY into the nearest electrical outlet.
R After you plug in the AC POWER SUPPLY you should see the /NTERCOM LED flash red and green. Consult the WORKSHEET above to
see which Station Number you have assigned to this telephone. Press that same number on the
MEMORY/lNTERCOM INDEX. The phone will beep, and the LED will start flashing red as it checks to see if this station address is already in use. If this station address is not already in use, the LED will turn off and the telephone will automatically conduct a “line check”. During the “line check” the line LED’s for each line con- nected will turn green. After a few seconds all LEDs will go off and you will here 3 beeps and the telephone should be fully functional.
Note: If you hear an error tone, the intercom number you pressed has already been assigned to another station or the TELEPHONE LINE CORDS are not properly connected. check the LINE CORD connections. Check the station.
Check the extension number assignments on your worksheet and repeat the procedure. (If you need to change the address of a station, refer
to page 28 in the Use and Care Guide)
Q. If you desire, you may turn off the ringer for any line or lines at any station. Press the STORE but- ton and you should see a red LED for each LINE button. The LED indicates the line is active and will ring. To disable a ringer press these buttons in this sequence to the right:
The LED should turn off, indicating a disabled ringer. Repeat this sequence for each ringer you wish to disable.
To turn a ringer back on: See page 23 of the accompanying USE AND CARE GUIDE.
Note: For complete information on the programming and use of
your GE Model
USE AND CARE GUIDE.
II
TO DISABLE RINGER
‘“ k
2.Omno
D
3“k
4. LINf 1 ■
w
