Installation Instruction
STEP 2 – ADJUST LEVELING LEGS
0RYHWKHGLVKZDVKHUFORVHWRWKHLQVWDOODWLRQ location and lay it on its back.
AdjustAdjustto to
Installation
Installation
Height
Height
Figure 8
0HDVXUHLQVWDOODWLRQKHLJKWDQGGLVKZDVKHUKHLJKW Extend leveling legs out from the dishwasher base, 1/4”less than installation height.
STEP 3 – REMOVE TOEKICK |
5HPRYHWKHWRHNLFNVFUHZV/LIWRIIWKHSLHFH |
toekick. |
Figure 9 |
STEP 4 – INSTALL POWER CORD
Skip this step if dishwasher will be direct wired. The power cord and connections must comply with the National Electrical Code, Section 422and/or local codes and ordinances.
Recommended power cord length is 54” min. and 64” max.
A | B Check That White, Black and | |
Remove | Green Dishwasher Wires Are Threaded | |
Junction Box |
| Thru Hole in Back |
Cover |
|
|
| Ground | White |
| Black | |
|
|
D seU LUistedL
Wire utsN
Figure 10
C
Inser t Power
Cord Wires Thru
Strain R elief
and Tighten
Connect incoming
power cord white (or ribbed) to dishwasher white. Black
(or smooth) to black. Ground to dishwasher green wire. Use UL listed wire nuts of appropriate size. Replace junction box cover . Be sure wires are not pinched under the cover .
STEP 5 – INSTALL 90° ELBOW
Wrap 90 elbow with thread seal tape.
Install a 90 elbow onto the water valve.
Fill
Hose
90 Elbow
Water
Valve
Bracket
| Thread |
Figure 11 | Seal Tape |
'RQRWRYHU7LJKWHQHOERZZDWHUYDOYHEUDFNHW could bend or water valve fitting could break. 3RVLWLRQWKHHQGRIWKHHOERZWRIDFHWKHUHDURIWKH dishwasher .
6