GE GFK0579B Display I/O Modules in Remote Drop, ID#143 R0 S2 32PT 120VAC %I 1 nxt, ID#143 R0 S4

6

Display I/O Modules in Remote Drop

When you enter the Configure Block screens, the Hand held±Monitor displays the configuration of the first I/O module in the remote drop. An example is shown below. This is a read±only function; I/O module configuration cannot be changed with the Hand±held Monitor. Note that these displays will indicate the presence of Analog Expander (16±channel analog), PCM, GDS, ADS, Bus Receiver (BERA), Bus Transmitter (BETA), jumper modules and empty slots, even though none of these can be configured by the Hand±held Monitor.

ID#143 R:0 S:2 32PT 120VAC %I 1 nxt

For each module, the display shows:

Hthe Remote Drop ID (143 in this example)

HR: the rack number. For Remote I/O Scanner version IC697BEM733A, this must be rack 0.

HS: the module's slot number

H% the module's I/O type

Hthe beginning I/O reference (in the example above, 1 in the third line represents %I0001).

Pressing F4 (nxt) displays the next module. For example:

ID#143 R:0 S:3 32PT 120VAC %Q 1 nxt

In this example, the module in rack 0, slot 3 is a 32±point output board. Its beginning output reference is %Q0001.

If a slot is not occupied, the HHM displays:

ID#143 R:0 S:4

EMPTY SLOT

nxt

Press F4 (nxt) to continue going through the module screens.

94 Series 90±70 Remote I/O Scanner User's Manual ± July 1992