Leveling Leg

Installation Instructions

INSTALLING THE WASHER (cont.)

7.With the washer in its final

position, place a level on top of the washer (if the washer

is installed under a counter, the washer should not be able to rock). Adjust the front leveling legs up or down to ensure the washer is resting

solidly. Turn the lock nuts on each leg up toward the base of the washer and snug with a wrench.

NOTE: Keep the leg extension at a minimum to prevent excessive vibration. The farther out the legs are extended, the more the washer will vibrate.

If the floor is not level or is damaged, you may have to extend the rear leveling legs.

8.Attach U-shaped hose guide to the end of the drain hose. Place the hose in a laundry tub or standpipe and secure it with the cable tie provided in the enclosure package.

NOTE: Placing the drain hose too far down the drain pipe can cause a siphoning action. No more than 7 inches of hose should be in the drain pipe. There must be an air gap around the drain hose. A snug fit can cause a siphoning action.

Cable Tie

Cable Tie

Cable Tie

9.Plug the power cord into a grounded outlet.

NOTE: Check to be sure the power is off at the circuit breaker/fuse box before plugging the power cord into an outlet.

10.Turn on the power at the circuit breaker/fuse box.

11.Read the rest of this Owner’s Manual. It contains valuable and helpful information that will save you time and money.

12.Before starting the washer, check to make sure:

†Main power is turned on.

†The washer is plugged in.

†The water faucets are turned on.

†The unit is level and all four leveling legs are firmly on the floor.

†The shipping support hardware is removed and saved.

†The drain hose is properly tied up.

†There are no leaks at the faucet, drain line or washer.

13.Run the washer through a complete cycle. Check for water leaks and proper operation.

14.If your washer does not operate, please review the Before You Call For Service section before calling for service.

15.Place these instructions in a location near the washer for future reference.

REPLACEMENT PARTS

If replacement parts are needed for your washer, they can be ordered in the United States by visiting our Website

at GEApplianceparts.com or by calling 800.GE.CARES. In Canada, visit geappliances.ca or call 1.800.561.3344.

23

Page 23
Image 23
GE GFWS3705, GHWS3605, GFWS2605, GFWS2505, GFWS2500 Replacement Parts, Before starting the washer, check to make sure