GE JGB905, JGB915 Using the self-cleaningoven, Instructions Operating Instructions Safety

Models: JGB915 JGB905

1 60
Download 60 pages 62.61 Kb
Page 30
Image 30
Using the self-cleaning oven.

Instructions

Using the self-cleaning oven.

The oven door must be closed and all controls set correctly for the cycle to work properly.

Instructions Operating Instructions Safety

Wipe up heavy soil on the oven bottom.

Before a Clean Cycle

For the first self-clean cycle, we recommend venting your kitchen with an open window or using a ventilation fan or hood.

Remove the broiler pan, broiler grid, all cookware, probe and any aluminum foil from the oven—they cannot withstand the high cleaning temperatures.

NOTE:

If your oven is equipped with nickel oven shelves, remove them before you begin the self-clean cycle.

If your oven is equipped with gray porcelain-coated oven shelves, they may be left in the oven during the self-clean cycle.

Soil on the front frame of the range and outside the gasket on the door will need to be cleaned by hand. Clean these areas with hot water, soap-filled scouring pads or cleansers such as Soft Scrub®. Rinse well with clean water and dry.

Do not clean the gasket. The fiberglass material of the oven door gasket cannot withstand abrasion. It is essential for the gasket to remain intact. If you notice it becoming worn or frayed, replace it.

Wipe up any heavy spillovers on the oven bottom.

Make sure the oven light bulb cover is in place and the oven light is off.

IMPORTANT: The health of some birds is extremely sensitive to the fumes given off during the self-cleaning cycle of any range. Move birds to another well ventilated room.

Consumer Support Troubleshooting Tips Installation

How to Set the Oven for Cleaning

Touch the SELF CLEAN pad.

Using the number pads, enter the desired clean time, if a time other than 4 hours is needed.

Clean cycle time is normally 4 hours. You can change the clean time to any time between 3 hours and 5 hours, depending on how dirty your oven is.

Touch the START pad.

The door locks automatically. The display will show the clean time remaining. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED DOOR light goes off.

When the LOCKED DOOR light is off, open the door.

The oven shuts off automatically when the clean cycle is complete.

The words LOCK DOOR will flash and the oven control will signal if you set the clean cycle and forget to close the oven door.

To stop a clean cycle, touch the

CLEAR/OFF pad. When the LOCKED DOOR light goes off indicating the oven has cooled below the locking temperature, open the door.

30

Page 30
Image 30
GE JGB905, JGB915 installation instructions Using the self-cleaningoven, Instructions Operating Instructions Safety