www.GEAppliances.com
Safety
Use a sewing needle or
Burner Caps and Heads
NOTE: Before removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning.
Burner caps
Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove
Burner heads
For proper ignition, make sure the
small hole in the section that fits over the electrode is kept open. A sewing needle or wire
The slits in the burner heads must be kept clean at all times.
Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.
Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.
You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool.
To remove
After cleaning
Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.
Replacement
Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size.
Medium head |
|
|
|
|
|
|
|
|
|
|
| Small head | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Front of range
Large head | Extra large head |
Make sure the slot in the burner head is positioned over the electrode.
Replace the matching size caps onto the heads.
Medium cap |
|
|
|
|
|
|
|
|
|
|
| Small cap | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Front of range
Large cap | Extra large cap |
Instructions Operating Instructions Installation Instructions Troubleshooting
NOTE: Do not use steel wool or scouring powders
Make sure that the heads and caps are
to clean the burners. This can damage the burners and electrically short the electrodes.
replaced in the correct locations.
33
