External device common settings

When using WebView Livescope MV ver. 2.0, if external device settings are made, all names will be reflected in MV.

Detail Settings

Picture Recording and output : triggered by external device

Use this setting to operate the Picture Recording function when recording is performed in conjunction with an external device such as a sensor or switch.

For a detailed example of actual operation, see Chapter 6, "Using the Picture Recording Function". (P.118)

"External Device Input 1/2"

 

"Recording at ON event"

 

Tick this option to record pictures when an

 

"ON" event is detected from an external

 

device.

 

"Recording between ON event and OFF event"

 

Tick this option to record pictures for as

 

long as an "ON" status continues from the

 

external device.

 

"Recording at OFF event"

 

Tick this option to record pictures when an

 

"OFF" event is detected from an external

 

device.

 

"Camera Position"

 

 

Selects the camera angle used when

3

pictures are recorded. Select "Not

specified", "Home 1" to "Home 4" or

 

"Preset 1" to "Preset 8".

 

Setup

proceeds an ON or OFF event, use this

"Pre-event Recording (sec.)"

 

When you want to save the pictures that

 

setting to enter the required number of

Procedures

seconds.

 

"Post-event Recording (sec.)"

 

When you want to save the pictures that

 

follows an ON or OFF event, use this

 

setting to enter the required number of

 

seconds.

 

"Recording Interval between events"

 

Records pictures at set intervals between

 

ON and OFF event. Specify a value

 

between 10 and 600 seconds as the

 

sampling interval.

 

"Output to External Device 1/2"

 

Tick this check box when you want to

 

control output to an external device. Keep

 

in mind that output to an external device

 

may not always be possible from Admin

 

Viewer or WebView Livescope MV ver.

 

2.0.

 

"Delay from OFF event (sec.)

 

When controlling output to an external

 

device and output must retain ON after

 

input is set to OFF, use this setting to

 

specify a delay of up to 20 seconds.

 

"Set operation time"

 

When you tick this option, input from an

 

external device is limited to the operation

 

time specified below. Enter the start time

 

and end time for the intervals during

 

which external input is acceptable.

 

"Handle ON/OFF input in reverse"

 

On some devices, ON and OFF are

 

reversed. Use this setting for such devices.

 

49

Page 49
Image 49
Canon VB101 appendix Setup, External device common settings