Canon VB101 appendix Using the Enclosed Software, Restoring the Factory Default Settings, 160

Using the Enclosed Software

Restoring the Factory Default Settings

Use the "IniVB101.exe" and "inivb101.elf" files in the same directory on the enclosed CD-ROM to

restore the VB101 settings to the factory default values.

1	Connect the VB101 to your PC (→ P.33), insert the enclosed CD-ROM
	into the CD-ROM drive and launch the "IniVB101.exe" program.
	When the "IniVB101.exe" dialog box appears, perform steps to
2
	below to restore the factory default settings.

1Select direct connection to COM1 as the connection method.

●On some PCs you may have to select a port other than COM1. Check the port number to which the serial cable is connected.

2 Switch the VB101 off and then on again.

3Enter the password (the default setting is "VB101").

● When you switch the VB101 on again, the [Next] button is enabled.

4 When the confirmation message

appears, click the [OK] button.

●The factory default setting are restored

●Refer to P.162 for the factory default settings.

●When you click the [Cancel] button after switching the VB101 back on, the c power LED remains lit orange. At this point, the VB101 software has not

Note	started up. If you do not need to change the settings, switch the VB101 to
	off and then on again and check that the power LED is green. To begin the
	setup procedure again, launch "IniVB101.exe" and then switch the VB101
	off and on again as directed by the on-screen instructions.

●If you forget the password, you will have to return the VB101 to a service center. Please contact your Canon dealer.

160