Detail Settings
Static Route Control
Route settings are required when communicating with a
"Default route"
The same setting can be made at "Default gateway address" on the Basic Settings settings page. Specify the route that would normally be used. A gateway address is required if a router on the Ethernet side is used.
"Route
Use this setting if you require connection routes other than the normal route. You can select either Ethernet or PPP as the interface. Specify the destination route in the Destination and Mask fields. You must specify a gateway address if you are using a router on an Ethernet network.
Connection Keeping
"Send packet regularly"
When this is selected, an ICMP Echo packet is transmitted periodically to a specified address in order to maintain the network connection.
"Target Address"
Specify where the PING should be sent.
"Interval(min)"
In minutes from 1 to 60, specify the interval at which PING should be sent.
For the packet target address in the connection keeping function, we c recommend that you consider the impact on traffic conditions and set the IP
Note address that is nearest after the auto
Router
Internet
ISDN/leased line/
ADSL, etc
VB101
Click the [OK] button to change the settings. To discard the changes, click the
[Cancel] button. This returns you to the settings title page.
42