Detail Settings

Application Settings Page

Use this page to specify settings for each application. Only the application selected as the "Target Application" (P.38) in the Basic Settings settings page is shown on this page.

When WebView Livescope is selected

"Restrict Service Time"

When you want to set service time for WebView Livescope Viewers, tick this option and specify the Start and End times.

The Admin Viewer can be used to display pictures at times other than the time specified. (P.88)

WebView Livescope

"Video Transmission Port"

Sets the TCP port number for the WebView Livescope video transmission protocol. Enter an integer between 1 and 65535. The default setting is 65310.

"Camera Control Port"

Sets the TCP port number for the WebView Livescope camera control protocol. Enter an integer between 1 and 65535. The default setting is 65311.

"Maximum Number of Clients"

Sets the maximum number of clients that can be connected simultaneously from the WebView Livescope Viewer. Enter an integer from 1 to 40.

"Control Queue Length"

Sets the length of the queue when multiple clients are waiting for control privilege under the WebView Livescope Viewer.

Enter an integer between 0 and 40. The maximum number is 40. When set to "0", only the Admin Viewer is permitted to control the camera.

"Maximum Frame Rate (fps)"

Sets the maximum number of frames captured per second. Enter a number between 0.1 and 30. The maximum frame rate is 30 fps.

"Maximum View Time (sec)"

Sets the maximum time the client can view videos using the WebView Livescope Viewer. Enter an integer between 1 and 65535. A setting of 0 disables the time limitation.

"Maximum Camera Control Time (sec)" Sets the maximum time for which camera control privilege can be maintained under the WebView Livescope Viewer. Enter an integer between 1 and 3600.

"Still Video Capture Delay Wait Time (msec.)"

When the GetStillImage command (P.114) has been requested, this setting specifies the delay to allow the camera to stabilize before still picture is captured. Enter an integer between 0 and 10000. The maximum delay is 10000 milliseconds.

3

Setup Procedures

e If you want to restrict video service time, use "Restrict Service Time".

Tip

55

Page 55
Image 55
Canon VB101 appendix Application Settings, When WebView Livescope is selected