GE JGBC18, JGBS18 manual To Set the Clock, To Set the Timer, To Change or Cancel the Timer Setting

Models: JGBC18 JGBS18

1 48
Download 48 pages 50.75 Kb
Page 11
Image 11

(on some models)

Follow the directions below if your range has the clock and timer shown at the right.

You have the choice of having the timer show the time counting down or the time of day. In either case, the timer will signal at the end of the timer period to alert you that the time is up.

CLOCK a

 

w

T:~:~

 

 

A

(Appearance may vary)

 

To Set the Clock

NOTE: When you first plug in the range or after a power failure, the entire C1oc~imer display will light up.

1.Press the CLOCK pad.

2.Press and hold the+ or – pad and the time of day will change 10 minutes at a time. To change the time by single minutes, give the pads short taps.

3.Press the CLOCK pad to start the clock.

To Set the Timer

1.Press the TIMER ON/OFF pad.

2.Use the + and – pads to set the timer. Short taps on the + or – pad change the timer’s setting one minute at a time. Pressing and continuing to hold the + pad increases the setting ten minutes at a time.

3.Once you have set your timer, press the TIMER ON/OFF pad to start timing.

As the timer counts down, a signal will indicate when one minute is left. After this signal, the display will count down in seconds. When time runs out, a final signal will sound. Press the TIMER ON/OFF pad to stop the signal.

To Change or Cancel the Timer Setting

When the timer is counting down, use the+ and – pad to change the remaining time, or press the TIMER ON/OFF pad to stop the timer. The timer cannot be cancelled unless you have fully completed “set timer” instructions above.

Display Clock While Timer Is Operating

Pressing the CLOCK pad while the timer is operating will not interfere with the timer’s operation; the display will change to show the clock, but the timer will continue to count down and will still signal when time is up. Press the TIMER ON/OFF pad again to change the display back to show the timer.

Clock

Follow these directions if your range has the clock and timer shown at the right.

To set the clock, push in the knob and turn it to the right. Let the knob out when the clock hands reach the correct time. Continue turning the knob to OFF.

\12

,,.\\ooFF 1,,{

~.~4 /, ,

,:1O ~ ::,

20..

,.*< j~ \\\\’ ~

@“’/11,,1 , , \

/

(Appearan~e may vary)

Timer

The timer has been combined with the range clock. Use it to time all your precise cooking operations. You’ll recognize the timer as the pointer that is different in color than the clock hands.

Minutes are marked up to 30, and hours are marked up to 4 on the center of the clock.

To set the timer, turn the knob to the left—without pushing in—until the pointer reaches the number of minutes or hours you want to time.

At the end of the set time, a buzzer sounds to tell you time is up. Turn the knob—without pushing in—until the pointer reaches OFF and the buzzer stops.

11

Page 11
Image 11
GE JGBC18, JGBS18 manual To Set the Clock, To Set the Timer, To Change or Cancel the Timer Setting