Installation Instructions
36″ Sealed Gas Cooktop
JGP628, JGP630, JGP963, JGP970,
JGP975, ZGU36
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
IN THE COMMONWEALTH OF MASSACHUSETTS:
•This product must be installed by a licensed plumber or gas fitter.
•When using
•A flexible gas connector, when used, must not exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•IMPORTANT — Save these
instructions for local inspector’s use.
•IMPORTANT — Observe all governing codes and ordinances.
•Note to Installer – Be sure to leave these instructions with the Consumer.
•Note to Consumer – Keep these instructions for future reference.
•Product failure due to improper installation is not covered under the Warranty.
WARNING — This appliance must be properly grounded.
•IMPORTANT — Leak testing of the appliance shall be conducted according to the manufacturer’s instructions.
•Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty.
WARNING — Disconnect all electrical power at the main circuit breaker or fuse box before installing.
FOR YOUR SAFETY:
WARNING — If the information in this manual is not followed exactly, a fire, explosion or gas leak may result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance!
WHAT TO DO IF YOU
SMELL GAS:
•Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
This cooktop has been design certified by CSA International. You’ll find safety precautions in your Owner’s Manual.
Read them carefully.
•Installation of this cooktop must conform with local codes or, in the absence of local codes with the National Fuel Gas Code, ANSI Z223.1/NFPA
•Be sure your cooktop is installed properly by a qualified installer or service technician.
•To eliminate reaching over surface burners, cabinet storage above burner should be avoided.
•Do not install the unit near an outside door or where a draft may affect its use.
1 |