GE JGP970, JGP630, ZGU36 warranty Making The Lp Conversion, 1SAFETY INFORMATION YOU SHOULD KNOW

Installation Instructions

MAKING THE LP CONVERSION

1SAFETY INFORMATION YOU SHOULD KNOW

The pressure regulator and burner orifices are set for natural gas. To use Propane Gas, the regulator and burner orifices must be converted. The LP orifice spuds for the cooktop burners can be located in the literature package attached to the regulator.

CAUTION: The cooktop, as shipped from the factory, is set for use with natural gas. If you wish to use your cooktop with Liquefied Petroleum (Propane) gas, you must first replace the orifices and convert the pressure regulator.

WARNING: This conversion must be performed by a qualified installer or gas supplier in accordance with the manufacturer’s instructions and all codes and requirements

2ADJUST YOUR COOKTOP FOR USE WITH LP GAS

ADisconnect all electrical power, at the main circuit breaker or fuse box.

BShut off the gas supply to the cooktop by closing the manual shut-off valve.

CAdjust the pressure regulator, by the following instructions:

•Unscrew the cap.

•Place your thumb against the flat side of the spring retainer and press down to remove the retainer.

•Carefully look at the spring retainer to locate the NAT or LP position.

Cap Gasket

of the authority having jurisdiction. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion.

CAUTION: The following adjustments must be made before turning on the burner. Failure to do so could result in serious injury.

LP

NAT

LP

NAT

NAT.

Position

NAT

LP

	Spring
NAT	Retainer
LP

L.P./Propane

Position

OFF FOR

DOWN

Be sure pressure regulator has been converted as described in Step 2.

TOOLS YOU WILL NEED

FOR LP CONVERSION

Phillips Head	7mm Nutdriver
Screwdriver
	No. 15 Torx-Head
Pliers	Driver
	Small Flat-Head
Safety Glasses	Screwdriver (4mm
	or 5/32″ tip size,
	60mm long)

Pressure Regulator

•Turn the spring retainer over so that LP is showing on the bottom.

•Snap the retainer back into position.

•Screw the cap back onto the regulator.

13