Installation Instructions
MAKING THE LP CONVERSION (CONT.)
3
CHANGE COOKTOP BURNER ORIFICES
3CHANGE COOKTOP BURNER ORIFICES (CONT.)
A
B
C
Remove the top grates, burner caps, and burner heads.
Remove the spark igniters from the burner base (if required to access the orifices). Using a No. 15 “Torx” head driver bit, remove the screws holding the burner base in position.
Using a 7mm nut driver, remove the top burner orifices. These may be accessed through the hole in the cooktop.
Remove
This
Assembly
Orifice Spud Located Through This Opening
Burner cap
Burner
head
NOTE: On most burners,
the orifices have a spring- loaded retaining ring
around the hex head to hold the orifice in the nut driver during installation
and removal. A slight amount of force is required to push the nut driver down over the ring.
| Burner |
Spark igniter | base |
|
18,000 BTU Burner (on some models)
Burner
cap
Burner head
Burner
base
Spark igniter
14