GE JGSC12 Care And Cleaning, Range Top Burners, Oven Shelves, To replace the burners

CARE AND CLEANING

Oven Shelves

Clean the shelves with an abrasive cleanser or

steel wool. After cleaning, rinse the shelves with clean water and dry with a clean cloth.

Range Top Burners

The holes in the burners must be kept clean at all times for proper ignition and an even, unhampered flame.

You should clean the burners routinely, especially after bad spillovers which could clog these holes. Burners lift out for cleaning, if the shipping screw

Bu

s Valve

was removed at installation.

Do not re

Orifice

NOTE: A screw holds each burner in place to keep them from wobbling around during shipment. Remove and discard the shipping screw. Be careful not to remove the screws from the igniter bracket.

screws fr igniter br

To remove the burners:

1.Grasp the burner head and tilt it to the right to release the two tabs from slots in the burner support.

2.Lift the end of the burner assembly, then pull away from the front of the range to free the air shutter from the gas valve orifice.

To remove burned-on food, soak the burners in a solution of mild liquid detergent and water or a solution for cleaning the inside of coffee makers, such as Dip-It@ brand. Soak the burners for 20 to 30 minutes. If the food does not rinse off completely, scrub them with soap and water and a brush or plastic pad. Do not use steel wool or abrasive cleansers because they will clog the burner openings and scratch the burners. If the holes become clogged, clean them with a small sewing needle or a small safety pin.

Do not attempt to clean burners in an automatic dishwasher. Loosened food soil can clog burner holes, and the strong action of the dishwasher detergent can damage the burner heads.

Before putting the burners back, shake out excess water and dry them thoroughly by setting them in a warm oven for 30 minutes.

r Ports

Lig

—

r Support

Air

To replace the burners:

1.Slip the air shutter over the gas valve orifice.

2.Lower the burner assembly and hook the tabs in the slots in the burner support.

3.Be sure both tabs are in their slots, that the burner sits level and straight, and that the flash tube forms a straight line from the igniter to the burner.

—

20