GE JMP31WR, JMP32AR, JMP28GR, JMP29GR manual Clock, Timer

Models: JMP29GR JMP28GR JMP31WR JMP32AR

1 32
Download 32 pages 48.78 Kb
Page 9
Image 9

Clock

The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a TIME BAKE or CLEAN cycle.

To Set the Clock

Step 1: Press the

 

Step 2: Press the

CLOCK pad.

 

INCREASE or

CLOCK

A

DECREASE pad to

 

n

J set the time of day.

Step 3: Press the CLOCK pad to start,

Timer

The timer is an alarm or minute timer only. The timer does not control oven operations. The maximum setting on the timer is 9 hours and 55 minutes.

To Set The Timer

Step 1: Press the

TIMER pad.

TIMER

The timer will start automatically within a few seconds of releasing the pad.

The timer, as you are setting it, will display seconds until 60 seconds is reached.

Step 2: Press the INCREASE or DECREASE pad to set the amount of time on timer.

Then it will display minutes and seconds until 60 minutes is reached.

After 60 minutes, it will display hours (“HR” now appears in display) and minutes until the maximum time of 9 hours and 55 minutes is reached.

To Reset Timer

It “TIMER” is showing, press the INCREASE or DECREASE pad until desired time is reached.

If “TIMER” is not showing, press the TIMER pad first then follow instructions above to set the timer.

To Cancel Timer

Press the TIMER pad until the word “TIMER” quits flashing on the display (about 4 seconds).

Power Outage?

After a power outage, when power is restored, the display will flash and time shown will no longer be correct-for example, after a

5-minute power interruption the clock will be 5 minutes slow.

The display flashes until the clock is reset. All other functions that were in operation when the power went out will have to be programmed again.

End of Cycle Tones

The end of cycle tone is three short beeps followed by one beep that repeats every six seconds until you press any operation. If you would like to eliminate the repeating beeps, press and hold the CLEAIUOFF pad for ten seconds.

To return the timer tone to the repeating beeps, press and hold the CLEAR/OFF pad for 10 seconds.

Display Messages

If “door” appears on the display, the door is open. Close the door. If “LOCK” appears on the display, the oven door is in the locked position. BAKE, BROIL and COOK TIME cannot be set if the door is in the locked position.

9

Page 9
Image 9
GE JMP31WR, JMP32AR, JMP28GR, JMP29GR manual Clock, Timer