Instructions
Using the surface units.
NOTE: Throughout this manual, features and appearance may vary from your model.
Operating Instructions Safety
Be sure you turn the control knob to OFF when you finish cooking.
How to Set
Push the knob in and turn in either direction to the setting you want.
At both OFF and HI the control clicks into position. You may hear slight clicking sounds during cooking, indicating the control is keeping the power level you set.
AHOT COOKTOP indicator light will glow when any radiant element is turned on, and will remain on until the surface is cooled to approximately 150°F.
Surface unit indicator light will:
■come on when the unit is hot to the touch.
■stay on even after the unit is turned off.The WARM setting on the right REAR surface unit keeps already heated food warm until ready to serve.
Care and Cleaning
Using the Bridge Burner
To use the bridge burner, turn the control knob to the BRIDGE settings.
For full bridge burner operation, turn on the rear burner.
To use only the front burner, turn the control knob to the FRONT settings.
Using the Surface Warmer (on some models)
Consumer Support Troubleshooting Tips
SURFACE
WARMER
SET•OFF
WARMER GUIDE| SETTING | FOOD |
(Low) | Bread/Pastries |
(Medium) | Chocolate/Butter |
(Medium) | Plate of Food |
(Medium) | Sauces, Stews, |
| Cream Soups |
(Medium) | Vegetables |
(High) | Soups (liquid) |
(High) | Tea or Coffee |
The Warmer Guide is for reference only and the SETTING that you need will depend on the amount and type of food, the starting temperature of the food, and the length of the holding time.
6
The SURFACE WARMER, located in the center of the glass cooktop surface, will keep hot, cooked food at serving temperature. Always start with hot food. Do not use to heat cold food. Placing uncooked or cold food on the SURFACE WARMER could result in
Touch the SURFACE WARMER SET•OFF pad once for low warming, twice for medium warming or three times for high warming.
Touch the START pad.
To turn the SURFACE WARMER off, touch the SURFACE WARMER SET•OFF pad until WARMER disappears from the display.
For best results, all foods on the SURFACE WARMER should be covered with a lid or aluminum foil. When warming pastries or breads, the cover should be vented to allow moisture to escape.
Always use potholders or oven mitts when removing food from the SURFACE WARMER, as cookware and plates will be hot.
CAUTION: Do not warm food on the SURFACE WARMER for more than two hours.
NOTE: The surface warmer will not glow red like the cooking elements.
HOT will be displayed when the glass surface is hot and will remain on until the surface is cool enough to touch.
NOTE: Lower settings may not heat the glass surface enough to cause the HOT indicator light to come on.
An indicator light will glow when the unit is on.
■Do not use plastic wrap to cover food. Plastic may melt onto the surface and be very difficult to clean.
■Use only cookware recommended for
