GE JVM239 Be Certa~ Power Is Off Before Clea~G W Part Of T~ Oven, Keep your oven dm and sweet

Keep your oven dm and sweet-

am~q Opening the oven door a few minutes after coobfok~p air out the inside. An ~. through wiping with a solution of bting soda and water bps the inside fresh.

Wn’t M sharp+ed uti on yom oven. The inside and outside oven walls can be scratched. The contil panel can be damaged.

BE CERTA~ POWER IS OFF BEFORE CLEA~G W PART OF T~ OVEN.

W* md floor. Some spatters a be removed wifi a paper towel, otiers may ~uire a damp cloth. Remove greasy spatters witi a sudsy cloth, then rinse with a damp cloth. Do not use abrasive claers on oven walls. NEVER USE A COMMERcw Om

CMANER ON ANY P~T OF YOUR mCROWAVE OVEN.

Mr (iAde). Window: Wipe up spatters daily and wash when soiled with a damp cloth. Rinse AorougMy and dry.

MeM and plastic parts on door: Wipe ~uentiy with a damp C1O* to remove dl soil. DO NOT USE ABRAS~S, SU~ AS C ~G POWDERS OR S- AND U~C PADS. WY -

DAMAGE ~ SURFACE.

S-note when - Brown ‘N* M: E grease is presen~ high heat generati on bottom of a Brow ‘N Sear dish may cause the grease to bum onto the oven tray. This may be removed with a cleanser such as Bon Ami” brand cleanser.

After using Bon Ami” brand cleanser, rinse and dry thoroug~ , following instructions on can. Do not use

.J eanser on the painted surfaces such Bon Anu brand c1

as the walls. It may scratch the paint.

Cm. Clean the oufiide of your oven witi soap and damp cloth, rinse with a damp cloth and then dry. Wipe the window clean with a damp cloth. Chine trim is best wiped with a damp cloth and then witi a dry towel.

Control Md. Wipe with a damp cloth. Dry *orougMy. Do not use cleaning sprays, large amounts of soap and water, abrasives or sharp obj=ta on the panel-they can damage it.

-r Sd- When cleaning surfaces of door and oven that mme together on closing the door, use only dd, non-abrasive soaps or detergents applied with a sponge or sofi cloti.

Power Cofi If the mrd becomes soilti, unplug and wash with a damp cloti. For stubborn spots, sudsy water may be used, but be mrtain to rinse with a damp cloth and dry thoroughly before plugging mrd into outiet.