GE JVM290 manual Questions? Use This Problem Solver

PROBLEM

OVEN WILL NOT COME ON

CONTROL PANEL LIGHTED. YET OVEN WILL NOT START

"PROBE" APPEARS ON DISPLAY

'Error" APPEARS ON DISPLAY

'HOT" APPEARS ON DISPLAY

FLOOR OF THE OVEN IS WARM. EVEN WHEN THE OVEN HAS NOT

QUESTIONS?

USE THIS PROBLEM SOLVER

POSSIBLE CAUSE

•A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or reset circuit breaker.

•Unplug your microwave, Convection oven. then plug it back in.

•Make sure 3-prong plug on oven is fully inserted into wall receptacle.

•Door not securely closed.

•START pad must be touched after entering cooking selection.

•Another selection entered already in oven and CLEAR/OFF pad not touched to cancel it.

•Make sure you have entered cooking time or temperature after touching one of the cooking pads.

•CLEAWOFF pad was touched accidentally. Reset cooking program and touch START pad.

•Temperature probe not inserted properly or not being used during Combination Roast or Temp Cook/Hold.

•Make sure you have entered a desired finished food temperature or oven temperature after setting temperature cooking programs.

•Make sure you have entered a code number after touching Sensor COOK.

•Temperature probe is missing or not plugged in securely when using cooking functions that measure food temperature.

•Temperature probe is inserted for a program that does not use the probe.

•During Cook, Reheat. Beverage or Popcorn program, the door was opened before steam could be detected, or steam was not detected in maximum time.

•This is normal when the temperature inside the oven is greater than 200 degrees and the door is opened.

•One of the sensor cooking pads was touched when the temperature inside the oven was greater than 200 degrees. These features will not operate when the oven is hot.

•The cooktop lamp is located directly below the oven floor. When the lamp is on. the heat it produces makes the oven floor get vv°arm. This is normal.

BEEN USED

All these things are normal with your microwave oven:

•Steam or vapor escaping from around the door.

•Light reflection around door or outer case.

•Dimming oven light and change in blower sound may occur while operating at power levels other than high.

•Dull thumping sound while oven is operating.

•Some TV-Radio interference might be noticed while using your microwave oven. It's similar to the interference caused by other small appliances and does not indicate a problem with your oven.

If you need more help...call, toll free: GE Answer Center _*/ 800.626.2000 / consumer information service

34