GE 49-4560-1, JVM72 manual L7’-=====o-A---‘

To replace hood lamp, first disconnect power at n’mhl fuse or ch’clm !’mWker panel or pull plug.

Remove 2 screws from each side of lower panel, steady the smoke and spatter shield with cmi hand while removing and replacing the 2 screws on each side. Then remove the 3 screws from front edge. Lower the panel until it rests on range below. Place

—

—

L7’—=====o-A:-—_—‘“.:

To replaee your oven lamp, first disconnect power at main fuse or circuit Im3aker or pull phqg.i?emov~the top grill by taking off 2 screws which hold it in place, Next, remove the single screw cm top left that secures lamp housing, (On models so equipped,) Open oven door for easier removalof the lamp hous- ing assembly,Then grasp tab and pull out and up to clear door hinge and front lip of oven, To remove bulb, push it inward gently and t~rri to left, then pull outward from socket, Replace with GE Lamp x 25T8DC,

00not attempt to operate the oven unless the grill is in pkim.

..—...

fingers on tap near each end of lamp. Press down and roll top of lamp gently toward front until it stops. Remove.Replacewith same type and wattage lamp. Hold lamp near each end and insert prongs in sockets. Gently roll top of lamp toward rear of range until it stops, Raiselower panel and replace screws.

—

Clean off the grease and dust cm hood surfaces often, Usea warm detergent solution. About 1table- spoon of ammonia may be added to the water, Take care not to touch the fiiters and enameled surfaces with this. Ammonia will tend to darken metal, Wash the smoke and spatter shield with a warm detergent solution,

29