9
Installation overview
The basic steps required to install the PBe are:
1.Physically connect the PBe interface to the network switch or hub and the DVR using the supplied cables.
2.Program monitor mode to on by setting SW1 switches 1 to 4. See SW1 switches 1 to 4 on page 20 for the switch settings.
3.Program the camera number to be associated with the ATM’s transaction data to the PBe. See SW1 switches 5 to 8 on page 21.
4.Program the DVR to record in the way desired for your specific site.
Required information
The following information is required for a successful PBe installation. This information is used to configure the PBe. You will need to contact the customer’s ATM network administrator for answers to these questions.
Ethernet device type
•Generic interface
•Native ATM messages (FC)
•Verifone POS
•Ethernet data analyzer
