18
ProBridge Ethernet User Manual
ins entered followed by the enter key. Changing the selection to on allows the PBe to monitor the incoming Ethernet packets.
Note: Monitor mode should be turned off before upgrading the PBe.
In some cases whenever SW3 is used to select the Ethernet Device, monitor mode will automatically be turned on.
Analyzer Mode menu
This menu is used for troubleshooting only. Do not use unless requested by a qualified technician.
Exiting HyperTerminal
To exit HyperTerminal do the following:
1.Enter the number 1 and the enter key until the message “Exiting menus Ready!” is displayed.
2.Close the HyperTerminal screen. You do not need to save the session for your changes to take effect.
1.Remove the
Manual DIP switch configuration
The Ethernet Device and Camera Selection can also be selected manually by changing the DIP switch setting see DIP switch settings on page 20. Follow the steps below to change the DIP switches:
1.Disconnect power from the PBe
2.Disconnect the PBe from the DVR.
