GE GSD6200, PDW7300, PDW7700, GSD6600, GSD6700, GSD6660 Control Module, Detergent/Rinse Module, 14

Control Module

Removal

1.Remove the outer door panel (see Door Compo- nents).

2.Open the door and remove the 3 screws from the back on the right side of the escutcheon keypad assembly.

3.Remove 1 screw from the right side of the control module and slide the module out.

4.Unplug the connectors from the module. Installation

Note: The gray cable is a factory test cable (see photo) and may be removed when servicing control module.

1.Plug connectors into control module.

2.Insert the tabs on the left side of the control module into the slots on the inner door panel and secure the module with 1 screw.

3.Install 3 screws on the right side of the escutch- eon and replace the outer door panel (see Door Components).

Detergent/Rinse Module

The door panel must be removed to access the detergent/rinse module. Refer to the Door Compo- nent section.

The detergent/rinse module can be activated using service mode. Refer to the Service Mode chapter.

The detergent/rinse module automatically dis- penses both the detergent and the rinse agent at the appropriate times. The module is activated 2 times during a wash cycle.

The first time the module is activated (1), the lever slides up the right-hand path of the connecting rod. This action releases the detergent cover. When deactivated (2), the lever returns down the left- hand path and comes to rest under the notch in the center of the connecting rod. At the second activation (3), the lever lifts the connecting rod by the notch. This action lifts the rinse dispenser plunger and releases the rinse agent. When deactivated, the lever returns to its original starting position.

2 Tabs 1 Screw

P0003697

Factory

Test Cable

Cover	Main
	wash
	section

Cover Pre-wash latch section

Rinse agent adjuster

Indicator
window	Dispenser cap

1 2 3

L1 Voltage from J2-6
		DOOR
	DETERGENT MODULE	INTERLOCK
J2-6	RY	WR	WX	N
		NO	COM
	1200-2800

– 14 –