DELAY HOURS You can delay the start of a wash cycle for up to 9 hours (on some models). Press the DELAY HOURS pad to choose the number of hours you want to delay the start of the cycle, then press START/RESET. The machine will count down and start automatically at the correct time. Pressing START/RESET a second time will cancel the DELAY START selection.
NOTE: If you forget to fully close the door a reminder signal will beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle. The START/RESET light will flash while the water is pumped out if needed. This takes approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed and restarted.
5 Start
Close the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad to begin the cycle. Water fill begins, and approximately 60 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher door is fully closed, the control panel lights will display the last settings you selected.
If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
If the door is closed the indicator lights will turn off if the START/RESET pad is not selected within two minutes. To activate the display, open and close the door or press any pad.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.
6 Clean
The CLEAN light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.
GE Models
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.
15
2 | 4 | 3 |
Control Settings
1 Status Indicator Lights
The Status display tells you what’s happening while the dishwasher is in operation and may flash, indicating a malfunction (see page 86). The lights will come ON indicating the sequence of operation the dishwasher is in.
SENSING Displayed while the ExtraClean™ Sensor is measuring the amount of soil and temperature of water. (on some models) The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash and main wash periods. (on some models)
RINSING Displayed during rinse periods. (on some models)
DRYING Displayed during HEATED DRY. (on some models)
SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is opened.
CLEAN Displayed when a wash cycle is complete. The light will remain ON until door is opened.
