Washability Complaints
Hot Water – Ample supply of water at a minimum temperature of 120 °F is necessary. Do not use dishwasher soon after using clothes washer or filling bath tub.
Loading – Consult Owner’s Manual on loading procedures.
Amount of Water – Make sure dishwasher is level. Check water level, allowing dishwasher to fill normally for first fill. The water level should be to the base (bottom) of the float dome. If water level is low, check for clogged screen in water valve and check flood switch. Refer to the Water Valve and Flood Switch section.
Detergent/Rinse Module Leakage – Some moisture in cup is normal. Detergent must not be soaking wet, oozing out and down the inner door panel. If a leak is detected, check the detergent/ rinse module door lid, latch operation, and gasket seal. Also refer to the Detergent/Rinse Module section.
Proper Amount of Detergent – Use full detergent cup of fresh detergent in hard water. Use only enough detergent to get good wash performance in soft water.
Rinse Agent – Use rinse agent if spotting or drying is a problem. A rinse agent will improve the water sheeting action and drying performance.
Water Valve – Refer to the Water Valve and Flood
Switch section.
Spray Arm – Check to be sure all 3 spray arms spin freely and jets are not clogged. Check to be sure the middle spray arm water conduit is con- necting properly to the main conduit.
Drying – Water inlet temperature must be at least 120 °F for proper drying. Low water inlet tempera- ture will prevent proper convection air movement and increase drying time substantially.
A rinse agent will improve the water sheeting action and drying performance.
Float Dome
Water Level
Cover | Main |
| wash |
| section |
Rinse agent
Cover Pre-wash latch section
Detergent/Rinse Module
