GE EDW4060, PDW7300, PDW7700, GSD6600, GSD6700, GSD6660, GSD6200, GSD6300 manual Circulation System, 18

Dishwasher Doesn’t Drain L1 Output from J2-5

DRAIN PUMP

J2-5RX M

30

DOOR
INTERLOCK
WR	WX	N
NO	COM

	Attempt
	to activate drain
	pump using service mode
	(refer to Service Mode
	chapter).
YES	Pump activate?	NO

Check for clogged: inlet cover sump

drain pump drain pipe one-way check valve (in drain pipe)

	Is L1
	voltage
	present at pump?
	Note: Perform this test
	with wiring connected
	and
YES		NO
	pump under
	load.

Check for open circuit between

Check pump for open/

control module and pump or

shorted motor winding or

between pump and door interlock

for stalled/clogged

switch. If circuits OK, replace

condition.

control module.

Circulation System

The circulation system consists of the following components:

•Inlet Cover

•Fine filter and sump filter

•Sump

•Circulation pump

•Hub

•Lower spray arm

•Main conduit

•Middle spray arm

•Upper Spray arm

The inlet cover prevents large particles from entering the sump. The fine filter (metal) and sump filter (plastic) prevent fine particles from entering the circulation-pump part of the sump (water entering the drain pump is not filtered by the fine filter or by the sump filter). The circulation pump is controlled by the control module and can be activated using service mode (refer to Service Mode chapter). The pump pushes water up

Circulation

PumpSump

Main Conduit	IInletl t Cover
Clip	((sump filtfilterr isis
	underr iinletl t cover)r)

Fine Filter

Hub

– 18 –