Installation Instructions
14
INSTALL THE FAUCET (CONT.)
5. Tighten the toggle screw until the base
is firmly in place and does not wobble
or turn.
6. Push the 3/8blue tube up to connect it to
the fitting on the bottom of the faucet body.
It should go in about 3/4. Pull tube slightly
to make sure it is secure.
7. Push the faucet body down into the faucet
base and turn the faucet 1/8 of a turn
counterclockwise until it stops into place.
NOTE:You can install the faucet so the
handle is on the right or the left side.
If you want the faucet handle on the right,
position the handle on the front-right side
of the base before turning 1/8 of a turn
counterclockwise.
If you want the faucet handle on the left,
position the handle on the rear-left side
of the base before turning 1/8 of a turn
counterclockwise.
8. Locate the hole at the rear
of the base. Insert the set
screw and begin to tighten
by hand. Finish tightening
with the Allen wrench
provided in the packet.
DO NOT OVERTIGHTEN.
Faucet body
Faucet base Sink
Gasket
Toggle screw 3/8Black tube

INSTALL THE FAUCET

Be sure there is room underneath and above
the sink to make the needed connections.
Before starting, make sure there is sufficient
room for the faucet base and unit. Select one
of the following places to install the faucet:
A.In an existing sink spray attachment or
soap dispenser hole.
B.In a hole to be drilled in the sink top.
C.In a hole to be drilled in the countertop,
next to the sink.
NOTES:
Be sure the faucet base will fit flat against
the surface at the selected location so the
bottom gasket between the base and
surface area will seal.
Make sure to leave enough clearance
at the back of the faucet in case you need
to remove it.

Installation Steps (refer to illustration

below for clarification)

1. If drilling is needed, make a 112diameter
hole. Be sure to use the proper procedure
for drilling porcelain or stainless steel.
Special drill bits may be needed. Consult a
qualified plumber for the proper procedure.
NOTE:When drilling in stainless steel, the
edges may be sharp and could puncture the
tube. Be careful to not cut yourself or damage
the tube.
2. Remove the faucet body and base by
turning the base counterclockwise.
3. Push the 1/4black tube and the 3/8black
tube onto the correct barb fittings on the
faucet base. Push the 3/8blue tube
through the base.
4. Align the gasket to cover the hole completely.
Then place the toggle screw on the base into
the hole.
Faucet base
Sink Gasket
Toggle screw
1/4Black tube
Faucet base
1/4Barb fitting
1/4Black tube
3/8Barb fitting
3/8Black tube
3/8Blue tube
3/8Blue tube
Mounting screw
Faucet Faucet
Faucet handle on the RIGHT Faucet handle on the LEFT
FAUCET ASSEMBLY