SafetyInstructions
Reversing the door swing.
Read these instructions completely and carefully.
Reversing the Hardware
Transfer Bottom Hinge Bracket to the Left (For freezer swing door models only.)
OperatingInstructions
a
b
c
d
Pull out grille 1″ (25 mm) and set it down on the floor to gain access to the hinge bracket screws.
Using a 3/8″ socket, remove the hinge bracket, screws, plastic washer and spacer shim from the bottom right side of the cabinet.
Remove plug button and screw from the bottom left side of the cabinet and install at the bottom right.
Reinstall the spacer shim, hinge bracket, screws and plastic washer to the bottom left side of the cabinet.
Plastic
Washer
Bottom Right
Plastic
Washer
TroubleshootingTips Installation Instructions
CustomerService
Bottom Left
Transfer Center Hinge Bracket to the Left
a Remove the center hinge bracket and shim by removing the three screws. NOTE: Keep these screws with the hinge bracket. They are longer screws and will be used when installing the hinge on the other side.
b | Remove the three painted screws and take | Center Right |
washers from the center left side of the cabinet. | ||
| Screw them into the holes on the right side, |
|
| which were uncovered in Step “a” above. |
|
c Place the center hinge bracket and shim over the holes at the center left side of the cabinet. Insert the three screws that were removed with the center hinge bracket in Step “a” and tighten securely.
Center Left
Do not install the hinge pin yet.
Transfer Top Hinge to the Left
Interchange hinge and shim at top right with two plug buttons at top left of cabinet. Do not tighten screws on hinge side at this time.
14
