20
Installation Instructions
InStaLLIng tHE WaSHEr (cont.)
7. Attach the U-shaped hose guide to the end of the
drain hose. Place the hose in a laundry tub or
standpipe and secure it with the cable tie provided in
the enclosure package.
nOtE: Placing the drain hose too far down the drain pipe
can cause a siphoning action. No more than 7 inches of
hose should be in the drain pipe. There must be an air
gap around the drain hose. A snug fit can also cause a
siphoning action.
8. Plug the power cord into a grounded outlet.
nOtE:Check to be sure the power is off at the circuit
breaker/fuse box before plugging the power cord into
an outlet.
9. Turn on the power at the circuit breaker/fuse box.
10.Read the rest of this Owner’s Manual. It contains
valuable and helpful information that will save you
time and money.
11.Before starting the washer, check to make sure:
oMain power is turned on.
oThe washer is plugged in.
oThe water faucets are turned on.
oThe unit is level and all four leveling legs are firmly
on the floor.
oThe shipping support hardware is removed
and saved.
oThe drain hose is properly tied up.
oThere are no leaks at the faucet, drain line
or washer.
12.Run the washer through a complete cycle.
Check for water leaks and proper operation.
13.If your washer does not operate, please review
the Before You call For Servicesection before
calling for service.
14.Place these instructions in a location near the washer
for future reference.
Cable Tie Cable Tie
If replacement parts are needed for your washer, they
can be ordered in the United States by visiting our
Website at GEAppliances.com or by calling
800.GE.CARES.
rEPLaCEMEnt PartS
Cable Tie