Installation Instructions
LOCatIOn OF yOUr WaSHEr
Do not Install the Washer:
1.In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60°F (15.6°C) for proper washer operation.
2.In an area where it will come in contact with curtains or drapes.
3.On carpet. The floor MUSt be a hard surface with a maximum slope of 1/2″ per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate or move, you may have to reinforce the floor.
nOtE: If floor is in poor condition, use 3/4″ impregnated plywood sheet solidly attached to the existing floor covering.
IMPOrtant:
Minimum Installation Clearances
•When installed in alcove: Sides, Rear, Top = 0″ (0 cm)
•When installed in closet: Sides, Rear, Top = 0″ (0 cm), Front = 1″ (2.54 cm)
•Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm2), located 3″ (7.6 cm) from top and bottom of door
|
| |
FRONT |
| |
27.0” | 2.2” | |
(68.6 cm) | ||
(5.6 cm) | ||
20.4” (51.9 cm) | ||
| ||
ELECTRONIC TRANSPARENT VISOR |
| |
| 40.6”* | |
| (103.1 cm) | |
SIDE |
| |
30.6” | 1.6” | |
(3.9 cm) | ||
(77.7 cm) | ||
| ||
| 40.6”* | |
| (103.1cm) | |
| 39.1” | |
| (99.2 cm) | |
*NOTE: With pedestal, 52.6” |
| |
Stacked, 84” |
|
16
